APPLICATION:
Sandblast all parts with 120 grit aluminum oxide.
DO NOT USE GLASSBEAD. Clean metal using convential
cleaning methods, with acetone, lacquer thinner or
other similar non-petroleum based solvent.When the
surface is clean and dry, apply a thin even layer of
coating using an airbrush, detail touch-up gun
or other spray equipment that allows for application of
a thin film of approximately .001" to .0015". Avoid
excessive build-up of material as this can lead to loss
of adhesion. DO NOT APPLY A SECOND COAT AFTER
THE COATING DRIES. Allow to air dry and Cure at 300f for 1 hour.
